Filter
Top Products
136
Menu List
Appendix
To recall the preset PIP settings
When you turn the F3 control to display PIP under DIRECT in SW mode, PIP: is displayed at the lower
left corner on the display panel. (If DIRECT is not displayed on the display panel above the F3 control,
press the F3 control once to display it.)
When you press numeric buttons 0 to 9 to enter the direct PIP number (0 to 9) beside PIP: then press the
RECALL button, you can recall the preset PIP setting.
You can also recall the preset PIP setting simply by pressing numeric buttons 0 to 9 if you press to light
up the DIRECT RECALL button.
SETUP Menu
If you changed the values of the setting items in the SETUP menu (menu pages 900s) and exit the menu,
a message “Reboot system? [PAGE] (yes) or [EXIT] (no)” or “Save setup data? [PAGE] (yes) or [EXIT]
(no)” may appear on the display panel depending on the changed setting items. Press the PAGE button
(yes) to reboot the switcher or to store the changed settings. The stored settings are retained in memory
when the switcher is turned off and on again. When the EXIT button (no) is pressed, the settings are
restored to those before your changes.
Note
Setting menu Setting item Description
900 CAMERA.. 910 VISCA.. 911 CONTROL RS-232C, RS-422 Sets up the connection with the VISCA
cameras.
Normally, keep MODEL set to Auto so that
the switcher detects the model automatically.
When all the connected cameras are of the
same model, you can also specify the
model.
To apply the changed setting, press the F4
control to execute APPLY.
BAUD 38400, 9600
MODEL Auto, BRC-300, BRC-H700,
BRC-Z700, BRC-Z330
APPLY
Exec
ASSIGN.. 912 CAM BTN 1, 2, 3, 4, 5, 6, 7 Allows you to assign the VISCA ID of the
desired camera to one of the CAMERA 1 to
7 buttons.
To change the assigned VISCA ID of the
camera, execute NET CHG.
NAME (4-character indication)
VISCA ID Off, 1 to 7
NET CHG
Exec
SENSE.. 913 ZOOM Constant, Variable Sets the sensitivity of reaction in camera
zoom and joystick movement.
Note
When ZOOM is set to Constant, the default
setting of SPEED (F2) is 4. When
JOYSTICK is set to Constant, the default
setting of SPEED (F4) is 8.
SPEED 1, 2, 3, 4, 5, 6, 7, 8
JOYSTICK Constant, Variable
SPEED BRC-300/300P/H700/Z330: 1
to 24
BRC-Z700: 0.5, 1 to 24
MODE.. 914 PAN DIR Normal, Reverse Sets the reaction of the joystick for panning/
tilting and zoom direction.
When BRIGHT is set to IRIS+G, IRIS and
GAIN can be changed by turning the F2
control if the exposure is set to MANUAL on
the BRC-H700, BRC-Z700 and BRC-Z330
camera.
TILT DIR Normal, Reverse
ZOOM
DIR
Normal, Reverse
BRIGHT IRIS, IRIS+G
POS RST.. 915 CAM BTN 1 to 7 Resets the preset value stored in the
camera position number that corresponds to
the CAMERA button.
FROM 1 to 99, All
TO 1 to 99
RESET
NOP, Exec
TALLY.. 916 MODE Off, CAM BTN, PGM Sets the illumination specification of the tally
lamp on the connected VISCA camera.