Filter
Top Products
26
Control Panel
Chapter 2 Locations and Functions of Parts
7 Camera Menu/Location Control Section
The buttons in this section differ in function depending on
whether the switcher is in CAM or SW mode.
The functions of the buttons are explained for both modes
individually.
x Functions in CAM mode
a CAMERA MENU button
When you hold this button pressed to light up the button,
the main menu of the camera is displayed on the image
shot by the camera selected with one of the CAMERA
buttons in the CAMERA/DSK/AUX bus section. Hold the
button pressed again to turn off the main menu.
If the selected camera has two or more main pages, each
press of the button switches the main menu to the next
page. After the last page is displayed, the main menu of the
camera disappears.
Holding the CAMERA MENU button pressed while any
setting menu of the camera is displayed restores the main
menu.
If the DATA MIX switch on the BRC-H700, BRC-Z700 or
BRC-Z330 camera is set to OFF, or the DATA MIX
switch on the BRU-H700 HD Optical Multiplex Unit is set
to OFF, the menu of the camera is not displayed on the
output image from the interface board installed in the
camera or the BRU-H700. For details, refer to the
Operating Instructions supplied with the camera or the
BRU-H700.
b Camera menu operation buttons (UP/DOWN/
LEFT/RIGHT/ENTER)
Use these buttons to operate the menu on the camera when
the menu is displayed on the image shot by the camera
selected with one of the CAMERA button in the
CAMERA/DSK/AUX bus section.
• Select the menu item from the main menu with the UP or
DOWN button then press the ENTER button to display
the selected setting menu.
• Select the setting item to be changed with the UP or
DOWN button then press the LEFT or RIGHT button to
change the setting value.
• To restore the main menu, hold the CAMERA MENU
button pressed.
The camera menu operation buttons in this section
function the same as the V/v/B/b/HOME buttons on the
Remote Commander supplied with the camera. For details,
refer to the Operating Instructions supplied with the
camera.
x Functions in SW mode
a CAMERA MENU button
This button cannot be used in SW mode.
b Location control buttons (FINE/CENTER/X/Y/Z)
Use these buttons to set the function of the joystick when
it is to be used in menu mode.
FINE button
Pressing to light up this button reduces the speed of setting
using the joystick. This enables you to make fine
adjustment. To restore the normal setting speed, press the
button again to make it go dark.
CENTER button
Pressing this button resets the setting data obtained using
the joystick to the factory preset settings.
X, Y and Z buttons
Pressing to light up one of these buttons enables the
following operation of the joystick:
X: to move the joystick horizontally
Y: to move the joystick vertically
Z: to turn the dial on the upper part of the joystick
Press one of these buttons again to make it go dark to
disable the corresponding operation.
CAMERA
MENU
LEFT
X
ENTER
Y
DOWN
CENTER
UP
FINE
RIGHT
Z
CAM
1 CAMERA MENU button
2 Camera menu operation buttons/
location control buttons
Note
Note