Filter
Top Products
36
Connecting External Equipment
Chapter 3 Preparations
Connecting a Video Output Device Such as a Camera Other Than a BRC-
Series Camera
Connect a camera or video output device equipped with an SDI output to the
SDI IN connector on the switcher.
Connecting a DVI Signal Output Device
To use an image output from the DVI output on a computer, install the optional
BRSA-20DD1 DVI input board in the IN1 or IN2 card slot on the switcher to
connect to the computer.
• To connect a computer that supports an analog RGB output signal only, use a
commercially available conversion cable (D-sub 15-pin y analog DVI).
• The video signal format to be used can be set to “HD” or “SD” under
“FORMAT” on menu page 951 (page 50). When it is set to “SD,” small
characters and fine graphics output from a computer may be blurred.
ANALOG IN
CONPOSITE Y/C
1234PGM1 PGM2 AUX1
SDI OUTSDI IN
5678
SDI IN
AUX2 REF IN REF OUT
RS-232C
~
AC IN
RS-422
DVI-I OUT
GENLOCK VISCA
GPI I/O PANEL LAN(10/100) REMOTE
IN1 IN2 OUT
T
W
A
B
H
O
L
D
l
s
L
j
G
/
S
J
SDI IN 1 to 4
Camera, etc. equipped with
an SDI output
Notes
1234PGM1 PGM2 AUX1
SDI OUTSDI IN
AUX2 REF IN REF OUT
RS-232C
~
AC IN
RS-422
DVI-I OUT
DVI-I IN
GENLOCK VISCA
GPI I/O PANEL LAN(10/100) REMOTE
5678
SDI IN
IN1 IN2 OUT
BRSA-20DD1 DVI input board (not supplied)
Computer
DVI-I IN