Filter
Top Products
80
Setting the Transition Time
Chapter 4 Switching Operation
Setting the Transition Time
The transition time indicates the duration of an effect from the beginning to the
end in units of frames.
You can set the transition time for executing a transition using the AUTO
TRANS, PIP AUTO or DSK AUTO button within the range of 0 to 999 frames.
1
Press to light up the SW mode button to set the switcher to SW mode.
The setting value of the transition time is displayed on the display panel
above the F4 control.
2
Press the F4 control to select the desired setting item.
ME
*
AUTO: to set the transition time for a mix or wipe effect
DSK AUTO: to set the transition time for a downstream key (DSK)
PIP AUTO: to set the transition time for picture-in-picture (PIP)
* ME is an abbreviation for Mix & Effect and indicates the mix and wipe transition effects.
3
Turn the F4 control to change the setting value.
You can set the transition time within the range of 0 to 999 frames in units
of frames.
You can also set the transition time on the following menu pages.
Menu page 943: ME AUTO, DSK AUTO, PIP AUTO
Menu page 760: DSK AUTO
Menu page 850: PIP AUTO
SW MODE MV TYPE XPT HOLD ME AUTO
SNAP: 4 Off
30
Note