Filter
Top Products
7-25
Cisco ONS 15600 Reference Manual, R7.2
Chapter 7 Circuits and Tunnels
7.13.3 Single and Dual Rolls
Figure 7-11 Single Roll from One Circuit to Another Circuit (Source Changes)
Note
Create a Roll To Circuit before rolling a circuit with the source on Node 3 and the destination on Node 4.
A dual roll involves two cross-connects. It allows you to reroute intermediate segments of a circuit, but
keep the original source and destination. If the new segments require new cross-connects, use the Bridge
and Roll wizard or create a new circuit and then perform a roll.
Caution
If you are using TL1 to perform rolls, this interface can only be used for single rolls. Dual rolls require
the network-level view that only CTC or CTM provide.
Dual rolls have several constraints:
•
You must complete or cancel both cross-connects rolled in a dual roll. You cannot complete one roll
and cancel the other roll.
•
When a Roll To circuit is involved in the dual roll, the first roll must roll onto the source of the
Roll To circuit and the second roll must roll onto the destination of the Roll To circuit.
Figure 7-12 illustrates a dual roll on the same circuit.
Figure 7-12 Dual Roll to Reroute a Link
Figure 7-13 illustrates a dual roll involving two circuits.
134274
Node 1
S
D
Node 2
Node 4Node 3
Original leg
New leg
S2
83268
Node 1
S
D
Node 2
Original leg
New leg