Filter
Top Products
13-8
Cisco ONS 15600 Reference Manual, R7.2
Chapter 13 SNMP
13.7.2 Variable Trap Bindings
B dsx3LineStatusChange
(from RFC 2496, not
applicable to
ONS 15600 but
applicable to other
platforms)
(1) dsx3LineStatus This variable indicates the line status of the
interface. It contains loopback state information
and failure state information.
(2) dsx3LineStatusLastChange The value of MIB II's sysUpTime object at the
time this DS3/E3 entered its current line status
state. If the current state was entered prior to the
last reinitialization of the proxy-agent, then the
value is zero.
(3) cerentGenericNodeTime The time that an event occurred.
(4) cerentGenericAlarmState The alarm severity and service-affecting status.
Severities are Minor, Major, and Critical.
Service-affecting statuses are Service-Affecting
and Non-Service Affecting.
(5) snmpTrapAddress The address of the SNMP trap.
C coldStart (from RFC
1907)
(1) cerentGenericNodeTime The time that an event occurred.
warmStart (from RFC
1907)
(2) cerentGenericAlarmState The alarm severity and service-affecting status.
Severities are Minor (MN), Major (MJ), and
Critical (CR). Service-affecting statuses are
Service-Affecting (SA) and Non-Service
Affecting (NSA).
newRoot (from RFC) (3) snmpTrapAddress The address of the SNMP trap (not supported for
ONS 15600).
topologyChange (from
RFC)
— — (Not supported for ONS 15600)
entConfigChange (from
RFC 2737)
—— —
authenticationFailure
(from RFC 1907)
—— —
Table 13-5 15600 SNMPv2 Trap Variable Bindings (continued)
Group Associated Trap Name(s)
(Variable
Binding
Number) SNMPv2 Variable Bindings Description