Filter
Top Products
1-18
Cisco ONS 15600 Reference Manual, R7.2
Chapter 1 Shelf and Backplane Hardware
1.11.2 ASAP Card Cables
1.11.2 ASAP Card Cables
To allow enough clearance between ASAP card cables and the front door on ONS 15600 shelf assembly,
you must install LC connectors with a connector boot angled downward at 45 or 50 degrees.
Figure 1-14 shows a 45-degree boot with LC connector.
Figure 1-14 Molex 45-Degree Boot with LC Connector
Figure 1-15 shows a 50-degree boot with LC connector.
Figure 1-15 Tyco 50-Degree Boot with LC Connector
This fiber boot should be part of your fiber-optics cable assembly, along with an LC connector.
You can obtain this boot from the following two vendor. Contact the vendor for specific part numbers:
Table 1-3 Card Ports and Line Rates
Card Ports Line Rate per Port
OC48/STM16 LR/LH 16 Port 1550;
OC48/STM16 SR/SH 16 Port 1310
4 physical interfaces; 4 ports per interface,
totalling 16 OC-48 ports per card
2488.32 Mbps (STS-48, STS-48c)
OC192/STM64 LR/LH 4 Port 1550;
OC192/STM64 SR/SH 4 Port 1310
4 physical interfaces; 1 port per interface,
totalling 4 OC-192 ports per card
9.95 Gbps (STS-192, STS-192c)
151977
151984