Filter
Top Products
Original Orientation
113
4
Simplex Scanning
The setting orientation differs depending on whether the width of original is
within or larger than 297mm (11.7”).
*1
Contact glass: Select when scanning from the exposure glass.
Original width 297mm (11.7”) or less wider than 297mm (11.7”)
When placing an original
on the exposure glass
⇒ p.116 “Placing the
Original on the Exposure
Glass”
Place the original so that the top
edge touches the top-left of the
exposure glass.
Place the original so that the top
edge touches the top-left of the
exposure glass.
When placing originals
on the ADF
⇒ p.117 “Placing the
Originals in the ADF”
Place the top edge of the original
first.
Place the original so that the top
edge is set on the far side of the
original table.
Setting when the net-
work TWAIN driver is
used
Set [
Orientation:
] to .
When the ADF is used, set [
Side:
]
to “ Simplex ”.
Note
❒ Set “ ADF ” or “ Platen glass
”
*1
in [
Document:
].
Set [
Orientation:
] to .
When the ADF is used, set [
Side:
]
to “ Simplex ”.
Note
❒ Set “ ADF ” or “ Platen glass
”
*1
in [
Document:
].
Settings for Send Scan
(Use [
Original Settings
] in
[
Scan Settings
] )
Select [
: 1 Sided
].
Note
❒ Because this is the initial val-
ue of this setting, you do not
need to change it.
Select [
: 1 Sided
].