Filter
Top Products
Registering Scan Settings
71
3
❒ When you select [Custom Resolu-
tion], you can specify the resolu-
tion within the range of 100dpi
through 1200dpi in 1dpi incre-
ments.
❖
❖❖
❖ Scan Size
This item lets you select the size of
the area to be scanned. You can se-
lect from the following options.
Auto Detect, A3S, A4S, A4R,
A5S, A5R, 11x17S, 8
1
/
2
x14S,
8
1
/
2
x13S, 8
1
/
2
x11RS,
8
1
/
2
x11S, 5
1
/
2
x8
1
/
2
R,
5
1
/
2
x8
1
/
2
S, B4JIS (Japanese In-
dustrial Standard)S, B5JISS,
B5JISR, Custom Area Setting
Note
❒ Original sizes that can be auto-
detected vary depending on
where you place the originals
(on the exposure glass or on the
ADF). See ⇒ p.110 “The Origi-
nal Sizes Available for Auto De-
tection” for details.
❒ When [Custom Area Setting] is se-
lected, specify the scanning area
for [Start Positn.] and [Scanning
Area].
❖
❖❖
❖ Position
Specify the position where scan-
ning starts when [Custom Area Set-
ting] is selected in the [Scan Size]
list.
Enter the offset from the reference
(start) point in millimeters or inch-
es.
Note
❒ This setting is enabled only
when [Custom Area Setting] is se-
lected in the [Scan Size] list.
❒ You can select millimeters or
inches to specify the position
using [Unit of Measure] in [2.Send-
Scan Settings] under the Scanner
Features menu. See ⇒ p.61
“Unit of Measure” for details.
❖
❖❖
❖ Scanning Area
Specify the position where scan-
ning ends when [Custom Area Set-
ting] is selected in the [Scan Size]
list.
Enter the offset from the position
specified for [Start Positn.], in mil-
limeters or inches.
Note
❒ This setting is enabled only
when [Custom Area Setting] is se-
lected in the [Scan Size] list.
❒ You can select millimeters or
inches to specify the position
using [Unit of Measure] in [2.Send-
Scan Settings] under the Scanner
Features menu. See p.61 “Unit
of Measure” for details.
❒ Make sure that you specify ver-
tical/horizontal positions and
scanning areas to be within the
available scan area. The availa-
ble scan area varies depending
on where you place the origi-
nals (on the exposure glass or
on the ADF).