Filter
Top Products
Getting Started Teledyne API T703 Calibrator Operation Manual
40
3.4.2. WARM UP
The T703 Photometric calibrator requires a minimum of 30 minutes for all of its internal components to reach a
stable operating temperature.
3.4.3. WARNING MESSAGES
Because internal temperatures and other conditions may be outside be specified limits during the calibrator’s
warm-up period, the software will suppress most warning conditions for 30 minutes after power up. If warning
messages persist after the 30 minutes warm up period is over, investigate their cause using the troubleshooting
guidelines in Section 11 of this manual.
To view and clear warning messages, press:
Once the last warning has
been cleared, the MESSAGE
FIELD will return to displaying
the currently selected TEST
FUNCTION and value.
Suppresses the
warning messages
Press CLR to clear the current
message.
If more than one warning is
active, the next message will take
its place.
NOTE:
If a warning message persists after
several attempts to clear it, the message
may indicate a real problem and not an
artifact of the warm-up period
STANDBY SYSTEM RESET
TEST GEN STBY SEQ MSG CLR SETUP
STANDBY SYSTEM RESET
TEST GEN STBY SEQ MSG CLR SETUP
STANDBY SYSTEM RESET
TEST GEN STBY SEQ MSG CLR SETUP
SYSTEM ANALOG CAL WARNING
TEST CLR SETUP
MSG returns the active
warnings to the message
field.
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Table 3-6 lists brief descriptions of the warning me
ssages that may occur during start up.
07223B DCN6378