Filter
Top Products
Operating the T703 Calibrator Teledyne API T703 Calibrator Operation Manual
56
6.3. STANDBY MODE
When the T703 Photometric Calibrator is in standby mode, it is at rest.
Some functions under the SETUP MORE DIAG submenu, those which conflict with accurate
creation of calibration gas mixtures (e.g. ANALOG OUTPUT STEP TEST) automatically place the
calibrator into STANDBY mode when activated
NOTE
The T703 calibrator should always be placed in STANDBY mode when not needed to produce calibration
gas.
This can be done manually by pressing the STBY button that appears when the calibrator’s display is
showing the top-level menu (see Figure 6-1).
When programming a calibration sequences the STANDBY step should always be inserted at the end of
the sequence.
07223B DCN6378