Filter
Top Products
Teledyne API T703 Calibrator Operation Manual Operating the T703 Calibrator
69
6.5.2.1. The GENERATE Step
This step operates and is programmed similarly to the GENERATE AUTO.
At the end of the programming sequence, the T703 firmware will automatically insert a DURATION step that
needs to be defined.
To insert a GENERATE step into a sequence, press:
INSERT STEP Submenu
SETUP X.X INSERT STEP: GENERATE
PREV NEXT ENTR EXIT
Starting at the INSERT STEPS
Submenu
EXIT discards the new
target concentration
ENTR accepts the new
target concentration
SETUP X.X GENERATE:0.0 PPB O3
0.000PCTO3ENTREXIT
SETUP X.X GENERATE:ZERO
ZERO ENTR EXIT
SETUP X.X 3) DURATION : 10.0 MIN
PREV NEXT INS DEL EDIT EXIT
Toggle to switch
between ZERO
AIR and O
3
modes.
SETUP X.X GENERATE:0.0 PPB O3
0 0 0 .0 PPB O3 ENTR EXIT
Toggle these
buttons to set the
target
concentration.
Toggle to scroll
through the
available units of
measure
SETUP X.X DURATION: 1.0 MIN
001.0 ENTREXIT
Toggle these
buttons to set
DURATION of this
step
07223B DCN6378