Filter
Top Products
Teledyne API T703 Calibrator Operation Manual Optional Hardware and Software
49
5. OPTIONAL HARDWARE AND SOFTWARE
This includes a brief description of the hardware and software options available for the T703 Photometric
Calibrator. For assistance with ordering these options, please contact the Sales department of Teledyne –
Advanced Pollution Instruments at:
TOLL-FREE: 800-324-5190
FAX: 858-657-9816
TEL: 858-657-9800
E-MAIL: api-sales@teledyne.com
WEB SITE: www.teledyne-api.com
5.1. CARRYING STRAP HANDLE (OPT 29)
The chassis of the T703 calibrator allows to attach a strap handle for carrying the instrument. The handle is
located on the right side and pulls out to accommodate a hand for transport. When pushed in, the handle is
nearly flush with the chassis, only protruding out about 9 mm (3/8”).
Installing the strap handle prevents the use of the rack mount slides, although the rack mount brackets, Option
21, can still be used.
CAUTION
A FULLY LOADED T703 WITH BOTH THE O
3
GENERATOR AND PHOTOMETER
OPTIONS INSTALLED WEIGHS ABOUT 16.3 KG (36 POUNDS).
TO AVOID PERSONAL INJURY WE RECOMMEND TWO PERSONS LIFT AND CARRY
THE CALIBRATOR.
MAKE SURE TO DISCONNECT ALL CABLES AND TUBING FROM THE CALIBRATOR
BEFORE CARRYING IT.
5.2. COMMUNICATION OPTIONS
5.2.1. SERIAL COMMUNICATIONS CABLES (OPT 60A, 60B, 60C, AND 60D)
For remote serial, network and Internet communication with the analyzer, the following communication cables
are available:
Option Type Description
60A RS-232
Shielded, straight-through DB-9F to DB-25M cable, about 1.8 m long. Used to interface
with older computers or code activated switches with a DB-25 serial connectors.
60B RS-232 Shielded, straight-through DB-9F to DB-9F cable of about 1.8 m length.
60C Ethernet Patch cable, 2 meters long.
60D USB Cable for connection between rear panel USB port and personal computer.
07223B DCN6378