Filter
Top Products
Teledyne API T703 Calibrator Operation Manual Operating the T703 Calibrator
67
6.5.1.7. Setting the Progress Reporting Mode for the Sequences
As sequences run, the T703 calibrator reports progress by displaying a message in the MODE field of the front
panel display (See Figure 3-1). There are several types of report modes available
Table 6-5: Sequence Progress Reporting Mode
MODE
DESCRIPTION
STEP
Shows the progress as the sequence name and step number. This is the traditional display.
Example: “SO2_Test-2”.
PCT
Shows the progress as a percent (0–100%) of the total sequence duration.
Example: “SEQ 48%”
ELAP
Shows the progress as days, hours, minutes and seconds elapsed, counting up from 0.
Example (<1 day): “T+01:30:25” (i.e. 1 hour, 30 minutes, 25 seconds elapsed)
Example (>=1 day): “T+1d30:25” (i.e. 1 day, 30 hours, 25 minutes elapsed)
REM
Shows the progress as days, hours, minutes, and seconds remaining, counting down to 0.
Example (<1 day): “T–01:30:25” (i.e. 1 hour, 30 minutes, 25 seconds remaining)
Example (>=1 day): “T–1d30:25” (i.e. 1 day, 30 hours, 25 minutes remaining)
To select a PROGRESS report mode, press:
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ
Make sure that the
calibrator is in standby
mode.
SETUP X.X
O3 CFG CLK PASS MORE EXIT
SETUP X.X
PRINT
SETUP X.X
PRNT EXIT
SETUP X.X
PREV NEXT INS PRNT EXIT
EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the
calibrator.
OTHERWISE ...
<SET EXIT
STEP PCT REM
Use these buttons to
choose a
8
<SET
07223B DCN6378