Filter
Top Products
Teledyne API T703 Calibrator Operation Manual Operating the T703 Calibrator
95
To access and navigate the VARS menu, use the following key sequence:
these settings unless
specifically instructed to by
Teledyne API’s Customer
Service personnel.
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ
Make sure that the
calibrator is in standby
mode.
SETUP X.X
O3 SEQ CFG CLK PASS EXIT
SETUP X.X
COMM DIAG EXIT
SETUP X.X
EXIT
Toggle to enter the correct
SETUP X.X 0) O3_PHOTO_LAMP=58.0 DegC
JUMP EDIT PRNT EXIT
SETUP X.X 1) O3_PHOT_LAMP=58.0 DegC
PREV
JUMP EDIT PRNT EXIT
SETUP X.X
PREV JUMP PRNT EXIT
SETUP X.X
Toggle these bottons to set
the upper span point of the
Test
Channel signal
In all cases:
discards the new
setting
accepts the
new setting
SETUP X.X
PREV JUMP PRNT EXIT
SETUP X.X
Toggle to turn this mode
SETUP X.X
PREV JUMP PRNT EXIT
SETUP X.X
Toggle to turn this mode
these settings unless
specifically instructed to by
Teledyne API’s Customer
Service personnel
SETUP X.X 5) STD_TEMP=25.0 DegC
PREV
JUMP EDIT PRNT EXIT
SETUP X.X 6) STD PRESS=29.92 In-Hg
PREV
JUMP EDIT PRNT EXIT
PREV JUMP EDIT ENTR EXIT
ENTR EXIT
Enter sign and number of
seconds per day the clock
gains (-) or loses(+)
07223B DCN6378