Filter
Top Products
NovaJet 800 Series Service Manual
Assembly\Disassembly 5-9
4. Disconnect the grounding flex cable from the large standoff before
removing the Keypad Assembly. See Figure 5-5 for location. Remove
the Keypad Assembly.
Figure 5-5. Keypad and Display Grounding Connections.
Install the Keypad and Display
1. Route the Keypad flex data and ground cables into the Right Cover
Assembly through the hole provided for the Keypad.
2. Place the Keypad into position and hold. Turn the Right Cover
Assembly over and position the Display Assembly onto the threaded
studs of the Keypad. Secure using four standoffs and washers.
Tighten by hand.
3. Attach the Keypad grounding flex cable to the cover standoff as
shown in Figure 5-5. Ribbon must be closer to the plastic side of the
cover with the contact side towards the ground strap.