Filter
Top Products
Assembly\Disassembly 5-47
NovaJet 800 Series Service Manual
Install the Y-Arm Assembly, Pinch Rollers, Slide Shaft, and AutoLoad
Sensor
1. Install the AutoLoad Sensor Assembly into the back part of the Y-
Arm Bracket. Torque to 6 in-lbs.
2. Route the AutoLoad Sensor wires through the four wire clamps on
the back part of the Y-Arm Bracket.
3. Install the Slide Shaft and its supports to the Y-Arm Assembly.
Torque to 8 in-lbs.
4. Insert the back compression spring onto the shaft of the pinch roller
and push the back of the shaft through the back of the Y-Arm
Assembly. Install the C clamp around the shaft of the pinch roller.
5. While compressing the forward pinch roller spring with a screwdriver
(or other flat object), position the pinch roller onto the Y-Arm
Assembly until the forward spring is located under the hole in the
Slide Shaft. Release the spring and verify that the spring enters the
hole in the Slide Shaft and that no kinks are present in the spring.
6. Perform steps 4 and 5 for all pinch rollers.
7. Secure the Y-Arm Assembly to the Platen. Torque to 15 in-lbs.
8. Install the Stabilizer Bracket, Carriage Assembly and Trailing Cable
Assembly following procedures outlined earlier in this chapter.
9. Install the Ink Delivery System following procedures outlined earlier
in this chapter.
10. Install the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
12. Perform the Head Height Adjustment procedures found in Chapter 3
of this service manual.