Kodak 800 SERIES Camcorder User Manual


 
Assembly\Disassembly 5-12
NovaJet 800 Series Service Manual
7. Disconnect the Leg Harness connection at the J6 location by grasping
the Leg Harness connector with thumb and forefinger and pulling
straight out.
8. Disconnect the Trailing Cable B connection at the J2 location. Use the
thumb and forefinger to pull up on the connector lock and remove the
Trailing Cable from the connector.
9. Disconnect the Trailing Cable A connection at the J1 location. Use the
thumb and forefinger to pull up on the connector lock and remove the
Trailing Cable from the connector.
10. Disconnect the Autoload Sensor connection at the J13 location by
grasping the Autoload Sensor connector with thumb and forefinger and
pulling straight out.
11. Disconnect the Vacuum Fan 1 connection at the J15 location by
grasping the Vacuum Fan 1 connector with thumb and forefinger and
pulling straight out.
12. Disconnect the Vacuum Fan 2 connection at the J4 location (60 inch
model only) by grasping the Vacuum Fan 2 connector with thumb and
forefinger and pulling straight out.
13. Disconnect the Power Supply Cooling Fan connection at the J17
location by grasping the Power Supply Cooling Fan connector with the
thumb and forefinger and pulling straight out.
14. Disconnect the E-Connect Power connection at the J18 location by
grasping the E-Connect Power connector with the thumb and forefinger
and pulling straight out.
15. Disconnect the ground straps going to the side plate and baseplate by
removing the screw located near the parallel port on the Main PWA.
16. Using care, remove the Main PWA by unscrewing the remaining
screws securing the Main PWA to the bracket. See Figure 5-7.