Filter
Top Products
Assembly\Disassembly 5-44
NovaJet 800 Series Service Manual
4. Remove the Stabilizer Bracket from the Y-Arm Assembly by removing
the four alignment Allen screws and washers located on the back of
the Y-Arm Assembly.
CAUTION
The Encoder Strip is not a field removable item. The en-
tire Stabilizer Bracket Assembly with the Encoder Strip is
to be replaced if the Encoder Strip is damaged.
Install the Stabilizer Bracket and Encoder Strip
1. Install the Stabilizer Bracket Assembly (with Encoder Strip) onto the Y-
Arm Assembly using the four alignment Allen screws and washers.
Hand tighten only.
2. Install the Chain Support Bracket onto the Stabilizer Bracket
Assembly by placing the Chain Support Bracket onto the Stabilizer
Bracket with a slight forward tilt.
3. Install the Carriage Assembly, Trailing Cable Assembly and Ink
Delivery System following procedures outlined earlier in this chapter.
4. Install the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
5. Perform the Head Height Adjustment procedures found in Chapter 3 of
this service manual.
Remove the Y-Arm Assembly, Pinch Rollers, Slide Shaft, and
AutoLoad Sensor
1. Remove the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
2. Remove the Ink Delivery System, Carriage Assembly and Trailing
Cable Assembly following procedures outlined earlier in this chapter.
3. Remove the Stabilizer Bracket Assembly following procedures outlined
earlier in this chapter.