Filter
Top Products
Assembly\Disassembly 5-18
NovaJet 800 Series Service Manual
5. Insert and hold the Power Supply into place while securing it with four
screws. Torque to 15 in-lbs.
6. Reconnect the Power Supply to the AC Entry Module by reattaching
the quick disconnect connection. Push the quick disconnect
assembly behind the Power Supply Bracket and out of sight.
7. Install the Main PWA, Top and Right Covers following procedures
outlined earlier in this chapter.
Remove Servo Motor
1. Remove the Top and Right Covers and the E-Connect Network
Assembly following procedures outlined earlier in this chapter.
2. Disconnect the Servo Motor connection (red and blue wires) at the J12
location on the Main PWA by grasping the Servo Motor connector with
thumb and forefinger and pulling straight out.
3. Remove the E-Connect Plate located below the Servo Motor. Move the
E-Connect power cable into the platen and out of the way.
4. Obtain the Belt Removal Tool, spin the movable side to shorten the
distance between the two brass pieces.
5. Insert the Belt Removal Tool between the Left Frame Assembly and
the Frame Tensioner. See Figure 5-10. Ensure that the movable side is
against the Left Frame Assembly and the non-movable side is against
the Frame Tensioner.