Filter
Top Products
NovaJet 800 Series Service Manual
Assembly\Disassembly 5-29
Encoder on the Carriage PWA. Ensure that the Carriage Coupler goes
over the top of Slide Shaft. Stretch out the Belt towards the Servo
Motor to ensure that there are no twists in it. Leave enough of the Belt
loop overhanging the left side to ensure that the left Carriage will not
bind in the Belt when installing the left Carriage.
7. While holding the Carriage Compression Spring in place on the right
Carriage, position the left Carriage above and to the left of the right
Carriage as shown in Figure 5-19. Slowly move the left Carriage down
and to the right until the Carriage Compression Spring and Carriage
Coupler are attached to the left Carriage. At this point, the left Carriage
should easily slide onto the Slide Shaft.
Figure 5-19. Left Carriage Installation.
8. Move the Carriage Assembly back and forth over the Slide Shaft to
ensure that the Belt is not binding on the Carriage Assembly.
9. Insert both Strain Reliefs (with Trailing Cables) onto the Carriage
Assembly by sliding it onto the Strain Relief Support until it snaps
firmly into place.
10. Place the Trailing Cables into the J1 connector locks on each of the