Filter
Top Products
NovaJet 800 Series Service Manual
Assembly\Disassembly 5-7
Figure 5-3. E-Connect Assembly Installation/Removal.
3. Put on an ESD wrist strap.
4. Slowly lower the E-Connector Assembly until you can disconnect the
power cable from the connection located near the center of the circuit
board.
Install the E-Connect Network Assembly
1. Connect the power cable to the connection located near the center of
the circuit board.
2. Hold the E-Connect Assembly in place and secure using 4 screws.
Torque to 15 in-lbs
3. Connect the small parallel cable and the network cable to the rear of
the E-Connect Assembly.