Filter
Top Products
Maintenance 3-37
NovaJet 800 Series Service Manual
MAINTENANCE
7. Continue performing steps 4 through 6 until the slow deadband adjustment is
correct.
Color Deadband Alignment
The color deadband alignments are necessary to ensure that the output images are being
produced with the highest quality standards available while using the ENCAD printer in a
bidirectional mode.
These adjustments help to compensate for any deviations that may have become apparent
due to the carriage speed and/or the type of media loaded. Precise calculations are being
performed to time the release of the ink drop so that they land on the media at the correct
location. Differences in media thickness make the distance that the ink has to fall vary
and this variable needs to be compensated for in the calculations.
To perform the Color Deadband Alignments:
1. Select “Utility Menu” from the Main Menu. This brings up the Utility Menu as
shown in Figure 3-19.
2. Select the “Calibration Menu” from the Utility Menu. This brings up the Calibration
Menu as shown in Figure 3-25.
Use Paper Calib
Paper Axis Test
Color Db Menu
Open Jet Menu
Paper Axis
Exit
*
Figure 3-25. Calibration Menu.
3. Select the “Color Db Menu” from the Calibration Menu.