Filter
Top Products
Maintenance 3-31
NovaJet 800 Series Service Manual
MAINTENANCE
12. To adjust the far right screw obtain the head height plate and
install into the service station access hole (service station must be
removed). Move the carriage assembly over the service station
access hole so the Micrometer measuring tip extends to the head
height plate surface. Adjust for 67 +/-3 reading the RED number
only.
13. Continue performing steps 10 through 12 until all six of the
stabilizer screws have been adjusted.
14. Reposition the Carriage to all of the adjustment positions and
verify that the measurements are correct.
15. Perform steps 6 through 15 as many times as necessary to
correctly accomplish this adjustment.
Color Calibration
This procedure describes how to check that the cartridges are properly
aligned for color plotting and should be followed each time the ink car-
tridges are installed. Figure 3-18 is a representation of how a color
calibration looks when printed.