Kodak 800 SERIES Camcorder User Manual


 
Troubleshooting 4-62
NovaJet 800 Series Service Manual
2. Ensure the reservoirs are attached to female valves properly at left
end of printer or this may cause ink starvation in the ink delivery
system after 10 minutes of print operations.
Figure 4-65. Cartridge Tubing Needle and Septum.
3. Ensure the septum connector assembly is tightly secure. The
assembly is composed of three parts which must be tightly
twisted together prior to installation and use.
4. Ensure the septum connector/cartridge tubing needle is properly
connected between the cartridge and carriage assembly - you
may have to reseat the assembly at the valve body. Replace
reservoir tubing needle and/or cartridge tubing needle if pressure is
lost after the procedure has been performed (a leak is present in
the line).
5. Replace the cartridge with a new one. Re-prime the line.
6. If ink cannot be pulled through the line using the EasyPrime device
ensure the device is functioning correctly by verifying suction and
check the 4 AA batteries in the unit.
7. Always run a color test @100% in the 2 pass print mode to verify
the proper pressure levels have been achieved within the cartridge.