Filter
Top Products
NovaJet 800 Series Service Manual
Assembly\Disassembly 5-41
5. Lift out the left side of the Service Station from the Platen and remove
the Service Station. Moving the Service Station farther to the right
might be required to release the left side of the Service Station.
Install the Service Station
1. To install the Service Station, position the Service Station inside the
Right Cover and place the left side of the Service Station into the
Platen.
2. Push down on the right side of the Service Station until the Service
Station snaps into place.
3. Slide the Carriage Assembly to the right and back into the home
position. Lower the Top Cover.
Remove the Trailing Cable Assembly
1. Remove the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
2. Position the Carriage Assembly to the right side of the center of the
Slide Shaft. Make sure that the Chain Guide on the Chain Support
Bracket is not blocking the Floating Carriage Cover or it may be very
difficult to perform these procedures.
3. Remove the three screws securing the Left Support Bracket to the
Floating Cover. Slide the Left Support Bracket to the left, away from
the Carriage Assembly and Floating Carriage Cover. Carefully move
the Floating Carriage Cover/Right Support Bracket Assembly to the
right.
4. Remove the Electronics Covers and release the left end of the Trailing
Cables from the Carriage PWAs.
5. Release the Strain Reliefs (with the Trailing Cables and ferrite
attached) from the Carriages.
6. Disconnect the Trailing Cable Assembly connectors at the J1 and J2
locations on the Main PWA. Use the thumb and forefinger to pull
forward on the connector lock and remove the Trailing Cables from
their connectors. See Figure 3-6.