Filter
Top Products
NovaJet 800 Series Service Manual
Assembly\Disassembly 5-33
5. Unlock the latch on the right end of the Carriage and lift up the right
end of the Carriage PWA. See Figure 5-20.
6. Slide the Carriage PWA to the right to remove the tab on the left end
of the Carriage PWA from the slot in the Carriage.
CAUTION
Failure to use an approved antistatic bag for storage or
shipment may cause damage to the Carriage PCB and
affect the Warranty.
7. Place the Carriage PWA in an ESD bag (antistatic bag) in preparation
for shipment to ENCAD for replacement or repair, or if it is to be
stored at your facility for repair.
Install the Carriage PWA
1. Put the tab on the left end of the Carriage PWA into the slot in the left
side of the Carriage. See Figure 5-20.
2. Ensure that no flex cables are underneath the Carriage PWA.
3. Push down the right end of the Carriage PWA until the latch snaps
into place.
4. Reattach all flex cables on the Carriage PWA.
5. Install the Carriage Assembly and Ink Delivery System following
procedures outlined earlier in this chapter.
6. Install the Top, Left and Right Covers following procedures outlined
earlier in this chapter.