Filter
Top Products
Assembly\Disassembly 5-16
NovaJet 800 Series Service Manual
Figure 5-8. Power Supply Removal.
To remove the Cooling Fan and AC Entry Module:
1. Remove the four screws located below the Right Baseplate securing
the Power Supply Bracket to the Right Baseplate. Remove the Power
Supply Bracket. See Figure 5-9.
2. Using a Phillips screwdriver and a 1/4” wrench or socket, remove the
Fan from the Right Baseplate.
3. Using a 1/4” wrench or socket, disconnect the AC Entry Module
ground from the ground stud on the Right Baseplate.
4. Remove the AC Entry Module by pressing in on the securing tabs until
the module is released.