Filter
Top Products
NovaJet 800 Series Service Manual
Assembly\Disassembly 5-11
Install Memory Module
1. Slowly push the Memory Module into place. Make sure the module is
fully seated.
2. Push the side clips towards the Memory Module until they hold the
module securely in place.
3. Install the Top and Right Covers following procedures outlined earlier
in this chapter.
Remove the Main Printed Wiring Assembly (PWA)
CAUTION
Integrated circuits may become weakened or damaged by
electrical discharge. Do not touch or work near integrated
circuits without wearing an ESD wrist strap.
1. Remove the Top and Right Covers following procedures outlined earlier
in this chapter.
2. Put on an ESD wrist strap.
3. Remove memory module following procedures outlined earlier in this
chapter.
4. Disconnect the Power Supply connection at the J8 location by
grasping the Power Supply connector with thumb and forefinger and
pulling straight out. See Figure 3-4 for jack locations.
5. Disconnect the Stepper Motor connection at the J7 location by
grasping the Stepper Motor connector with thumb and forefinger and
pulling straight out.
6. Disconnect the Servo Motor connection (red and blue wires) at the J12
location by grasping the Servo Motor connector with thumb and
forefinger and pulling straight out.