Filter
Top Products
Assembly\Disassembly 5-14
NovaJet 800 Series Service Manual
CAUTION
Failure to use an approved antistatic bag for storage or
shipment may cause damage to the Main PWA and affect
the Warranty.
17. Place the Main PWA in an ESD bag (antistatic bag) in preparation for
shipment to ENCAD for replacement or repair, or if it is to be stored at
your facility for repair.
Install the Main Printed Wiring Assembly (PWA)
CAUTION
Integrated circuits may become weakened or damaged by
electrical discharge. Do not touch or work near integrated
circuits without wearing an ESD wrist strap.
1. Put on an ESD wrist strap.
2. Remove the Main PWA from the ESD bag.
3. Align the Main PWA so that the serial and parallel connections
protrude out of the back of the printer and that the screw holes are
aligned to the holes on the power supply bracket.
4. Fasten the Main PWA to the power supply bracket with 8 in-lb of
torque. Ensure that the ground straps from the side plate and
baseplate are secured to the Main PWA by the screw located beside
the side plate nearest to the parallel port.
5. Connect the E-Connect Power connector to J18 on the Main PWA.
6. Connect the Power Supply Cooling Fan connector to J17 on the Main
PWA.
7. Connect the Vacuum Fan 2 (60 inch only) connector to J4 on the Main
PWA.