Filter
Top Products
Appendix
Chapter 8 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
112
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
"E" (or other numbers/letters) is already
displayed on the Function Number Display after
power-on.
Does the problem persist after turning the power off then
back on?
No
The scanner is operating correctly.
Ye s
Is "c" flashing on the Function Number Display, and is the
Check LED flashing as well?
Ye s
Close the ADF properly.
For details, refer to "How to Close the ADF" (page 19).
If the display does not return to ready ("1") after closing the ADF, check the items
in "8.4 Before You Contact the Scanner Service Provider" (page 121) first, then
contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service
provider.
No
Is "h" displayed on the Function Number Display during
scanning?
Ye s
There is no problem. The scanner is operating in protection mode. It will return to
normal when you continue scanning. Note that the interval to feed the documents
becomes longer in protection mode.
No
If the problem persists, check the items in "8.4 Before You Contact the Scanner
Service Provider" (page 121) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.