Filter
Top Products
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
150
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Specifying an Area Not to Detect Multifeed
[Intelligent Multifeed Function]
When there is paper of the same size attached to a
designated location on the page, the scanner memorizes the
location of the attachment and can be configured not to detect
multifeeds for that location. To configure this setting, you first
need to select [Check Overlapping (Ultrasonic)] or [Check
Overlapping and Length] in either the scanner driver’s setup
dialog box or the multifeed detection setting in "Method of
Multifeed Detection [Multifeed]" (page 145).
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 125).
2 From the listing on the left, select [Device Setting 2] J
[Intelligent Multifeed Function].
3 Select an operation mode and click the [OK] button.
For details about the procedure after this step, refer to "Ignoring
Multifeed for a Set Pattern" (page 82).
Mode Description
Manual mode Stops feeding the documents when a
multifeed is detected. You can resume
scanning by loading the documents back in
the ADF paper chute.
The size and location of the attachment are
not memorized.
Auto mode 1 Memorizes the size and location of the
paper attachment upon resuming the scan
when a multifeed is detected and the
document is loaded back in the ADF paper
chute. The memorized pattern is ignored
from the next scan.
Auto mode 2 Memorizes the size of the paper attachment
upon resuming the scan when a multifeed is
detected and the document is loaded back
in the ADF paper chute. The memorized
pattern is ignored from the next scan.
z By selecting the [Clear overlap pattern] check box, you
can erase the overlapping patterns (length, position)
that were memorized in Auto mode.
z In [Remember multifeed pattern at power-off], you can
select whether or not to keep the multifeed pattern
upon turning the power off. When [Remember] is
selected, you can use eight (pages worth) of the most
recent patterns the next time the scanner is powered
on.