Filter
Top Products
Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
28
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
How to Load Documents
1 Pull out the chute extension 1 and chute extension 2
according to the length of the document.
For details, refer to "1.5 Setting Up the ADF Paper Chute" (page 20).
2 Load the document in the ADF paper chute.
Set the document with its front side (scanning side) facing the ADF
paper chute.
3 Adjust the side guides to the width of the document.
Set the side guides so that there is no space left between the side
guides and the document. Otherwise, the document may be fed
skewed.
Remove all paper clips and staples. Reduce the amount
of documents if a multifeed or pick error occurs.
Make sure to keep the documents within the limit which is
indicated by the line on the inside of each side guide.
Line
Side Guide
Side Guide