Filter
Top Products
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
18
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section explains how to power on/off the scanner.
How to Turn the Power ON
1 Press the [Power] button on the scanner's operator panel.
D The power is turned on, and the [Power] button lights in green.
During initialization, the Function Number Display of the operator
panel changes as follows: "8" J "P" J "0" J "1". The scanner is
ready when "1" is displayed.
How to Turn the Power OFF
1 Press the [Power] button on the operator panel for more
than two seconds.
D The power is turned off, and the [Power] button switches off.
1.3 Turning the Power ON/OFF
The method by which the scanner is powered ON/OFF can be
specified from one of the following:
z Press the [Power] button on the operator panel
z Unplug the power cable then plug it back in
z Have the scanner turn ON/OFF in sync with the
computer's power
For details, refer to "Method of Turning the Scanner ON/OFF
[Power SW Control]" (page 152).
When you press the [Power] button, the Check LED will
flash once. Note that this is an initial diagnosis and not a
malfunction.
Check
Function
Send to
Scan
/Stop
Power
[Power] Button