Filter
Top Products
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
136
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Intelligent Multifeed
Function
When there is a paper of the same size attached to
a designated location on the page, configure the
scanner to memorize the location of the attachment
and not detect multifeeds for that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check Overlapping
and Length] in either the scanner driver’s setup
dialog box or the multifeed detection setting in
"Method of Multifeed Detection [Multifeed]" (page
145).
Manual mode / Auto mode 1 / Auto mode 2 Manual mode
Select to clear the overlap pattern (length, location)
memorized in Auto mode.
[Clear overlap pattern] check box Not selected
Specify whether or not to memorize the multifeed
pattern upon power-off.
Remember / Do not remember Do not remember
Number of paper
feeding retries
Configure this setting to change the number of
feeding retries when a pick error occurs.
1 to 12 times 3 times
Life Counter Alarm
Setting
Specify the replacement cycle for the consumables. Each consumable
10,000 to 2,550,000 sheets
(in increments of 10,000)
Pick roller:
100,000 sheets
Pad:
50,000 sheets
Power SW Control Specify the method by which the scanner is
powered ON/OFF.
Enable power switch / Disable power switch /
Enable USB power feeding
Enable power
switch
Item Description Parameter/Value Factory Default