Filter
Top Products
Chapter 4 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
50
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Configuring the
Scan Settings
Indications on Function Number Display
Display Description
8 Displayed when the scanner has just been powered on.
P Processing initialization.
0 Initialization is almost complete.
1 Ready to start scanning.
Indicates that the initialization was successfully completed.
This state is referred to as "ready".
Function
number
(flash)
A function number will flash after detecting a multifeed. This
indication prompts whether or not to memorize the overlap
pattern.
For details, refer to "Ignoring Multifeed for a Set Pattern"
(page 82).
c
(flash)
Indicates that the ADF was opened when the status was
ready ("1"). Note that the Check LED will also flash.
To return to ready (”1”) status, close the ADF by referring to
" How to Close the ADF" (page 19).
If the display does not return to ready (“1”) after closing the
ADF, turn the power off then back on.
If the problem still persists, contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service provider.
h
Indicates that the scanner is operating in protection mode.
The scanner may enter this protection mode if it is used for
many hours continuously under high room temperature.
Note that the interval to feed the documents becomes longer
in this mode, but it is not a malfunction. (The recommended
operating environment is 35°C (95°F) or less)
It will return to normal as you just continue scanning.
J
U
Indicates that a temporary error occurred during scanning.
The display will switch between either "J" or "U", and an
“error number”.
For information about the error details, refer to "Temporary
Errors" (page 102).
The display will return to ready ("1") if the [Scan/Stop] or
[Send to] button is pressed.
E
H
L
Indicates that a device error (alarm) occurred during
initialization or scanning.
The display will switch between either "E'", "H" or "L", and an
“alarm” number.
For information about the error details, refer to "Device
Errors" (page 102).
The display will return to ready ("1") if the [Scan/Stop] or
[Send to] button is pressed.
When this alarm occurs, turn the power off then back on.
If the problem still persists, contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service provider.
None The display switches off when the scanner enters power
saving mode.
Display Description