Filter
Top Products
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
140
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Adjusting the Start Position for Scanning
[Offset/Vertical magnification Adjustment]
When the output position of the scanned image is not correct
or the image appears shortened/elongated (vertically), use the
following procedure to adjust the offset and the vertical
magnification for correction.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 125).
2 From the listing on the left, select [Device Setting] and
click the [Offset] button.
9.5 Settings Related to Scanning
Normally, you should not have to make any adjustments as the
factory default settings are configured at appropriate values.