Filter
Top Products
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
137
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Checking and Resetting the Counters
[Page Counter]
■Checking the counters
The status on each consumable part can be viewed to
determine when to replace the consumables.
The color of the counter changes to indicate that the
consumable needs replacement.
The [Device Setting] counter turns light yellow when the page
count after replacing the consumable reaches 95% of the
value specified in "Replacement Cycle of Consumables [Life
Counter Alarm Setting]" (page 139), and turns yellow when it
reaches 100%.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 125).
2 From the listing on the left, select [Device Setting].
In this dialog box, you can check the following items.
9.4 Settings Related to Page Counters
Item Description
Total Page Count
(ADF)
Approximate total number of sheets
scanned through the ADF
Pad Number of sheets scanned after
replacing the pad assy (in units of 500)
Pick roller Number of sheets scanned after
replacing the pick roller (in units of 500)
If the power was turned off by unplugging the power
cable, or [Disable power switch] is selected, up to nine
sheets may not be counted in [Total Page Count (ADF)].
For details about disabling the power switch, refer to
"Method of Turning the Scanner ON/OFF [Power SW
Control]" (page 152).