Filter
Top Products
Introduction
Glossary
Appendix
Glossary
Index
Contents
TOP
167
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Paper jam
Refers to a state in which a document is jammed inside the paper path, or feeding is
interrupted by documents slipping.
Patch code
A special code for the scanner to recognize the start and the end of each job or image
mode.
Pick roller
A roller which separates one sheet off the documents loaded in the ADF paper chute,
and feeds the document into the ADF.
Pick start time
Refers to the period of time from loading the document until picking starts after the
document passes the hopper empty sensor.
Pixel
The dots that make up a scanned image.
Portrait
Orientation in which the long side of the document is set parallel to the feed direction.
Documents/images are set/displayed vertically.
R
Resolution
A measurement to indicate the quality (fineness) of an image. Resolution is displayed
by the number of pixels within an inch. Since image data is a collection of small dots
(pixels), if the same image contains different amount of pixels, the one with more pixels
can express greater details. Therefore the higher the resolution, the finer the image
becomes.
S
Simplex scanning mode
A mode for scanning only one side (front or back) of the document. ( Q duplex scanning
mode)