Filter
Top Products
Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
83
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
Configuring the
Scan Settings
How to Use the
Operator Panel
Preparation before using this function
Configure the following settings before using this function:
1 Start up ScandAll PRO and select the [Scan] menu J
[Scanner Setting].
D The [TWAIN Driver (32)] dialog box appears.
2 Click the [Option] button.
D The [Option] dialog box appears.
3 Select the [Job/Cache] tab, and select [Check
Overlapping (Ultrasonic)] or [Check overlapping and
length] for [Multifeed Detection] under [ADF Option].
4 Select the [Startup] tab, and then select the [Enable
Scanner Panel] and [Enable [Scan] Button] check boxes.
5 Click the [OK] button.
D It returns to the [TWAIN Driver (32)] dialog box.
6 In the [TWAIN Driver (32)] dialog box, click the [OK]
button.
D The settings are saved.
If the [TWAIN Driver (32)] dialog box does not appear,
check the setting in ScandAll PRO by clicking the [Tool]
menu J [Preferences] to open the [Setup] dialog box,
then confirm that [TWAIN] is selected for [Device Driver]
in the [Scan] tab.