Filter
Top Products
Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
57
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
Configuring the
Scan Settings
How to Use the
Operator Panel
Long Page Scanning
Documents with a length up to 3,048 mm (120 in.) in feed
direction can be scanned by long page scanning.
1 Load documents in the ADF paper chute.
For details, refer to "Chapter 2 How to Load Documents" (page 26).
2 Start up ScandAll PRO and click the [Scan] menu J
[Scanner Setting].
D The [TWAIN Driver (32)] dialog box appears.
z Long page documents should be loaded one sheet at a
time in the ADF paper chute.
z Take note of the following when scanning long page
documents:
- Loading
Hold the sheet to prevent it from falling off the ADF
paper chute.
-Removing
Secure enough space around the stacker, and pick
up the ejected sheet to prevent it from falling off the
stacker.
To scan documents longer than A4/Letter size, perform
the following:
z Pull out the chute extensions 1 and 2 all the way.
For details, refer to "1.5 Setting Up the ADF Paper
Chute" (page 20).
z Lift up the stacker and stacker extension towards you.
For details, refer to "1.6 Setting Up the Stacker" (page
21).
If the [TWAIN Driver (32)] dialog box does not appear,
check the setting in ScandAll PRO by clicking the [Tool]
menu J [Preferences] to open the [Setup] dialog box,
then confirm that [TWAIN] is selected for [Device Driver]
in the [Scan] tab.