Filter
Top Products
Chapter 7 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
95
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
6 Remove the shaft.
Slightly pull up the left part of the shaft (about 5 mm), move it towards
the left side, and then lift it up.
7 Remove the pick roller from its shaft.
Pull out the shaft as you lift the retaining clip.
8 Attach a new pick roller on the shaft.
Insert the protrusion on the shaft into the slot.
The area around the pick roller may be contaminated by
paper dust which can cause scanning errors.
Wipe off the paper dust with a cloth moistened with
Cleaner F1.
Do not use any water, mild detergent or air spray.
2
Pick Roller
1
Shaft
Lifting the retaining clip with your fingernail may hurt or
damage your fingernail.
Use a paper clip or something alike if you have trouble
lifting it up.
Shaft
Retaining Clip
Pick Roller
2
1
Pick Roller
Slot
Protrusion
Shaft