Fujitsu FI-6110 Photo Scanner User Manual


 
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
135
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Item Description Parameter/Value Factory Default
Multifeed Specify a method for multifeed detection. Detect
multifeeds by monitoring the overlap, document
length, or the combination of both.
This setting can also be configured from the
scanner driver's setup dialog box. Note that priority
is given to the scanner driver setting.
None / Check Overlapping (Ultrasonic) /
Check Length / Check Overlapping and Length
Length: 10 / 15 / 20 mm
(for detection by document length)
None
Length: 10 mm
Page Edge Filler
(ADF)
Specify a width for the margin around the edge of
the scanned image to fill in white.
With TWAIN driver, this setting can also be
configured from the scanner driver's setup dialog
box. Note that priority is given to the setting with a
larger value.
Top / Left / Right: 0 to 15 mm
Bottom: -7 to 7 mm (in increments of 1)
(A: image, B: filled area, A+B: output)
Top/Bottom/Left/
Right: 0 mm
Dropout color Select a color to be removed from the scanned
image (only available in black & white or grayscale
mode).
With TWAIN driver, this setting can also be
configured from the scanner driver's setup dialog
box. Note that priority is given to the scanner driver
setting.
With ISIS driver, the scanner driver setting is
enabled at all times.
Red / Green / Blue / None Green
Document check area
specification for
Multifeed Detection
Selected range: Select this item to restrict the area
to run multifeed detection.
[Selected area] check box Not selected
Enable / Disable (Middle): Specify whether to enable
or disable multifeed detection in the selected area.
Enable / Disable
(When [Selected range] is selected)
Disable
Start (Middle): Specify the start position of the area
in length (mm) from the leading edge of the
document.
0 to 510 mm (in increments of 2) 0 mm
End (Middle): Specify the end position of the area in
length (mm) from the leading edge of the document.
0 to 510 mm (in increments of 2) 0 mm