Filter
Top Products
Calibration
Back
IndexContents
Next
87
6. Do one of the following:
✔ Click Finish to close the wizard and record
that the calibration is complete.
✔ Click Next to continue.
✔ Click Cancel to exit the wizard and wait to
send the new calibration data to the printer,
for example, if the printer is busy.
Changing Calibration Settings
You can change the calibration settings such as the
measurement source, the port where the
densitometer is connected, and the calibration
tolerance level. You can also set permanent color
adjustments to the prints.
1. From the Edit menu select Configuration.
2. Select or change options, as needed. See the
table on the next page.