Filter
Top Products
Calibration
Back
IndexContents
Next
77
Closing the Calibration Application
✔ Click the at the upper right of the
Configuration screen.
IMPORTANT: If you select Exit from the File menu,
all ML-500 applications close.
Calibration Process
Process Overview
1. Print a calibration target (see page 79).
2. Analyze a calibration target (see page 80).
3. Send the LUT to the printer (see page 83).
You can perform the steps separately, as listed
above, or perform all steps at one time by
performing a complete calibration analysis
(see page 86). If you select the latter option, some
of the steps in analyzing the target are skipped.
You may need to run more than one calibration
cycle to ensure that the printer's calibration is in
tolerance (see page 93).