Filter
Top Products
7
Chapter 7 Location and Function of Parts and Controls 136HDC-900/950/930 Series Product Information Manual
h BRIGHT control
Adjusts the brightness of the screen. This control has
no effect on the output signals of the camera.
i TALLY switch
Controls the tally indicator e located on the front of the
viewfinder.
HIGH: The tally indicator brightness is set to high.
OFF: The tally indicator is disabled.
LOW: The tally indicator brightness is set to low.
j ZEBRA (zebra pattern) switch
Controls the zebra pattern display on the viewfinder
screen as follows:
ON: A zebra pattern appears and stays.
OFF: The zebra pattern disappears.
MOMENT: A zebra pattern appears and stays for
about 5 seconds.
k DISPLAY/ASPECT switch
Turns the marker indication on and off, and switches
between 4:3 and 16:9 aspect ratios for viewfinder
screen display.
DISPLAY: When the marker indication is enabled with
the camera, the marker indication on the viewfinder
screen turns on and off every time you push the
switch up to this position.
ASPECT: Each push of the switch down to this position
toggles the mask display on and off.
7-15. HDVF-700A, HD Electronic Viewfinder
7-15-1 Appearance
1 PEAKING control
2 PEAKING switch
3 Friction adjustment knob
4 Lift-lock release knob
5 POWER switch
6 indicator
7 Green tally lamps
8 BRIGHT control
9 Lock lever
q; CONTRAST control
qa TALLY ON/OFF switch
qs BATT indicator
qd Red tally lamps
qf External tally lamp
qg External tally dimmer control
qh CAMERA connector
qj Mounting wedge
Front
Rear
Bottom