Filter
Top Products
7
Chapter 7 Location and Function of Parts and Controls 82HDC-900/950/930 Series Product Information Manual
7-2. HDC-950/930, HD Color Video Camera
7-2-1 Front Right Side
a INCOM (intercom 1) button
The intercom 1 microphone is turned ON while this
button is pressed.
b RET 1 (return video 1) button
The return video 1 signal from the camera control unit
is monitored on the viewfinder screen while this button
is pressed. It is the same function as with the RET 1
buttons on the sides.
c Y/RGB switch
Select the video signal output for the VF and TEST OUT
connectors.
Y: Output is the Y signal (this is the power-on default).
RGB: Output is the component video signal(s)
selected by the R/G/B switch.
d R/G/B (red/green/blue) switch
When the Y/RGB switch is set to RGB, select the
component video signal(s) to be provided as output to
the VF and TEST OUT connectors.
e ASSINABLE switch
You can assign a function using the OPERATION
menu.
f FILTER (internal filter selection) control
Used to select an internal filter appropriate for the light
source illuminating the subject.
g AUTO W/B BAL (white and black balance
automatic adjustment) switch1)
Used to automatically adjust white and black balance.
WHT: Automatically adjust white balance.
BLK: Automatically adjust black balance.
h CAMERA/VTR (switch1)
Used to select control signals sent to a VTR connected
to the camera. The operation of the VTR at the start of
recording for each setting is shown in the table below.
i GAIN (switch1)
Used to select the gain of the video amplifier based on
lighting conditions. The gain values for the L, M, and H
settings may be set using the menus. When shipped
qf MENU SEL knob/
ENTER button
1 INCOM button
2 RET 1 button
3 Y/RGB switch
4 R/G/B switch
5 ASSINABLE switch
6 FILTER control
7 AUTO W/B BAL switch
8 CAMERA/VTR switch
9 GAIN switch
q; OUTPUT/AUTO
KNEE switch
qa WHITE BAL switch
qs DISPLAY switch
qd
CANCEL/STATUS switch
ND filter
Color temperature
conversion filter
1 Clear A Cross filter
2 1/4ND B 3200K
3 1/8ND C 4200K
4 1/16ND D 6300K
5 1/64ND E 8400K
CAMERA VTR Function
OFF SAVE Turn off the camera power.
ON SAVE
Camera power is on. When
the VTR START button is
pressed, recording will begin
after a few seconds.
ON STBY
Turn on the camera power.
When the VTR START button
is pressed, recording will
begin immediately.