Sony 950 Camcorder User Manual


 
6
Chapter 6 A Quick Lesson on Camera Settings 69HDC-900/950/930 Series Product Information Manual
5. Press [Code Change].
The numeric keys and field for entering a New Code
No. are displayed.
6. Enter the desired code (1 to 8 digits) using the
numeric keys, then press [OK].
Note
Each digit you input will be displayed in an asterisk.
The message "Retype New Code No." is then
displayed.
7. Enter the same code you entered in step 5 once
again, then press [OK].
The security menu is restored.
8. Press [Exit].
The specific security code is now registered. When
you next press [Engineer Mode] on the security
menu, the numeric keys appear and the code input
is required. The MSU-700A/750 will enter the
Engineer Mode, if you enter the code properly and
press [OK].
6-3-1-2 To change the security code
When the registered security code must be changed,
proceed as follows.
1. Display the security menu items by following steps
1 through 3 of the above procedure for setting a
new code.
2. Press [Engineer Mode].
The numeric keys and field for entering the Code
No. are displayed.
3. Enter the old security code using the numeric keys,
then press [OK].
Note
Each digit you input will be displayed as an
asterisk. Security menu items now appear.
4. Press [Code Change].
The numeric keys and field - for entering the Old
Code No. are displayed.
5. Enter the old code, then press [OK].
The field for entering a New Code No. now appears.
6. Specify a New Code No. by following steps 6
through 8 of the previous procedure.
6-3-1-3 To enable to cancel the security code
To use a security code while in the Engineer Mode, it
is necessary to set the unit in a mode to use the
security code. If the operator forgets the security code,
or if an adjustment while in the Engineer Mode
becomes necessary in an emergency when the
authorized operator is absent, the security code can
be canceled by the following procedure:
Security Menu
Status
Engineer Mode
Code
Change
Engineer Mode
Exit
Code Change
OK Cancel
New Code
No:
987
654
321
0
Engineer Mode
OK Cancel
Code No:
987
654
321
0
Security Menu
Status
Engineer Mode
Code
Change
Engineer Mode
Exit
Code Change
OK Cancel
Old Code No:
987
654
321
0
New Code
No:
Code Change
OK Cancel
Old Code No:
********
987
654
321
0