Filter
Top Products
101
ZPL II Commands for RFID
^RM
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
^RM
Enable RFID Motion
Description Use this command to enable or disable RFID motion. By default, labels
automatically print at the end of the format. This command allows you to inhibit the label from
actually moving when it reaches the program position, which is useful for debugging, setup,
and custom applications. This parameter is not persistent (carried over from label to label).
Format ^RMe
This table identifies the parameters for this format.
Important • This command is not supported by all printers or firmware. See Printer and
Firmware Compatibility on page 82 for the list of printers and firmware with which you can
use this command.
Parameters Details
e = enable
Accepted values:
Y = Yes, move the label
N = No, do not move the label
Default value: Y