Filter
Top Products
143
SGD Commands for RFID
rfid.tag.test
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
rfid.tag.test
Description This command performs an RFID test. In the RFID test, the printer attempts to
read and write to a transponder that you place over the RFID antenna. Results are displayed on
the printer’s control panel display. To locate the RFID antenna on your printer, see RFID
Antenna Location on page 39.
In the slow version of the RFID test, the printer first displays the hardware version, the reader
firmware version, and the program position.
Type setvar
This table identifies the command for this format:
Note • This command is valid only on RP4T printers.
Commands Details
setvar
This command instructs the printer to set the programming position.
Format: ! U1 setvar "rfid.tag.test" "value"
Va lues :
quick
slow
Example • This setvar example performs a quick RFID test, which shows a pass or fail
message.
! U1 setvar "rfid.tag.test" "quick"
Example • This setvar example performs a slow RFID test, which shows the success or
failure of each read or write tag operation.
! U1 setvar "rfid.tag.test" "slow"